System characterization of dispersive readout in superconducting qubits
Daniel Sank, Alex Opremcak, Andreas Bengtsson, Mostafa Khezri, Jimmy Chen, Ofer Naaman, Alexander Korotkov
DOI 10.1103/PhysRevApplied.23.024055 · Physical Review Applied
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Designing quantum systems with the measurement speed and accuracy needed for quantum error correction using superconducting qubits requires iterative design and testing informed by accurate models and characterization tools. We introduce a single protocol, with few prerequisite calibrations, to measure the dispersive shift, resonator linewidth, and drive power used in the dispersive readout of superconducting qubits. We find that the resonator linewidth is poorly controlled, with a factor of 2 variation between the maximum and minimum measured values, and this variation is likely to require focused attention in future quantum error correction experiments. We also introduce a protocol for measuring the efficiency of the readout system using the same power levels as are used in typical qubit readout, and without the need to measure the qubit dephasing. We routinely run these protocols on chips with tens of qubits to a hundred qubits, driven by automation software with little human interaction. Using the extracted system parameters, we find that a model based on these parameters predicts the readout signal-to-noise ratio to within 10% over a device with 54 qubits.
Similar papers
Sequential Dispersive Measurement of a Superconducting Qubit
similarity 0.91T. Peronnin et al.
Source status unknown — claims are unverified
Fast high-fidelity quantum nondemolition readout of a superconducting qubit with tunable transverse couplings
similarity 0.90Bryan T. Gard et al.
Source status unknown — claims are unverified
Catch-Disperse-Release Readout for Superconducting Qubits
similarity 0.90Eyob A. Sete et al.
Source status unknown — claims are unverified
Approaching Unit Visibility for Control of a Superconducting Qubit with Dispersive Readout
similarity 0.90A. Wallraff et al.
Source status unknown — claims are unverified
Rapid High-fidelity Multiplexed Readout of Superconducting Qubits
similarity 0.90Johannes Heinsoo et al.
Source status unknown — claims are unverified
Dispersive regime of circuit QED: photon-dependent qubit dephasing and relaxation rates
similarity 0.90Maxime Boissonneault et al. · 2008 · arXiv:0810.1336
Source status unknown — claims are unverified