← Back to search

Anisotropy of the Optimally-Doped Iron Pnictide Superconductor Ba(Fe0.926Co0.074)2As2

M. A. Tanatar, N. Ni, C. Martin, R. T. Gordon, H. Kim, V. G. Kogan, G. D. Samolyuk, S. L. Bud'ko, P. C. Canfield, R. Prozorov

arXiv:0812.4991 · DOI 10.1103/PhysRevB.79.094507 · 2008-12-30

T1experimental1 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

Anisotropies of electrical resistivity, upper critical field, London penetration depth and critical currents have been measured in single crystals of the optimally doped iron pnictide superconductor Ba(Fe$_{1-x}$Co$_x$)$_2$As$_2$, $x$=0.074 and $T_c \sim$23 K. The normal state resistivity anisotropy was obtained by employing both the Montgomery technique and direct measurements on samples cut along principal crystallographic directions. The ratio $γ_ρ = ρ_c /ρ_a$ is about 4$\pm$1 just above $T_c$ and becomes half of that at room temperature. The anisotropy of the upper critical field, $γ_{H} = H_{c2,ab} /H_{c2,c} $, as determined from specific heat measurements close to $T_c$, is in the range of 2.1 to 2.6, depending on the criterion used. A comparable low anisotropy of the London penetration depth, $γ_λ=λ_{c}/λ_{ab}$, was recorded from TDR measurements and found to persist deep into the superconducting state. An anisotropy of comparable magnitude was also found in the critical currents, $γ_j=j_{c,ab}/j_{c,c}$, as determined from both direct transport measurements ($\sim$1.5) and from the analysis of the magnetization data ($\sim$3). Overall, our results show that iron pnictide superconductors manifest anisotropies consistent with essentially three-dimensional intermetallic compound and bear little resemblance to cuprates.

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
Ba(Fe0.926Co0.074)2As2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

23Pressure not reportedunknown
Ba(Fe0.926Co0.074)2As2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

22.5Pressure not reportedonset
Ba(Fe0.926Co0.074)2As2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

22Pressure not reportedmidpoint
Ba(Fe0.926Co0.074)2As2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

21.6Pressure not reportedzero_resistance

Similar papers