Superconducting microstrip amplifiers with sub-Kelvin noise temperature near 4 GHz

M. P. DeFeo; B. L. T. Plourde

doi:10.1063/1.4742164

← Back to search

Superconducting microstrip amplifiers with sub-Kelvin noise temperature near 4 GHz

M. P. DeFeo, B. L. T. Plourde

arXiv:1206.2235 · DOI 10.1063/1.4742164 · 2012-06-11 · Applied Physics Letters

T316 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We present measurements of an amplifier operating at 3.8 GHz with 150 MHz of bandwidth based on the microstrip input-coil resonance of a dc superconducting quantum interference device (SQUID) with submicron Josephson junctions. The noise temperature is measured using two methods: comparing the signal-to-noise ratio of the system with and without the SQUID in the amplifier chain, and using a modified Y-factor technique where calibrated narrowband noise is mixed up to the SQUID amplifier operating frequency. With the SQUID cooled to 0.35 K we observe a minimum system noise temperature of 0.55 $\pm~0.13$ K, dominated by the contribution from the SQUID amplifier.