Microstructural and transport properties of superconducting FeTe0.65Se0.35 crystals
A. G. Sivakov, S. I. Bondarenko, A. I. Prokhvatilov, V. P. Timofeev, A. S. Pokhila, V. P. Koverya, I. S. Dudar, S. I. Link, I. V. Legchenkova, A. N. Bludov, V. Yu. Monarkha, D. J. Gawryluk, J. Pietosa, M. Berkowski, R. Diduszko, R. Puzniak, A. Wisniewski
arXiv:1611.08455 · DOI 10.1088/0953-2048/30/1/015018 · 2016-11-25 · Superconductor Science and Technology
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
The issue concerning the nature and the role of microstructural inhomogeneities in iron chalcogenide superconducting crystals of FeTe0.65Se0.35 and their correlation with transport properties of this system was addressed. Presented data demonstrate that chemical disorder originating from the kinetics of the crystal growth process significantly influences the superconducting properties of an Fe-Te-Se system. Transport measurements of the transition temperature and critical current density performed for microscopic bridges allow us to deduce the local properties of a superconductor with microstructural inhomogeneities, and significant differences were noted. The variances observed in the local properties were explained as a consequence of weak superconducting links existing in the studied crystals. The results confirm that inhomogeneous spatial distribution of ions and small hexagonal symmetry nanoscale regions with nanoscale phase separation also seem to enhance the superconductivity in this system with respect to the values of the critical current density. Magnetic measurements confirm the conclusions drawn from the transport measurements.
Source-reported materials — not catalogue approval
| Formula | Reported Tc (K) | Pressure (GPa) | Type |
|---|---|---|---|
| FeTe0.65Se0.35 Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | — | Pressure not reported | unknown |
| FeTe0.65Se0.35 Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | — | Pressure not reported | unknown |
Similar papers
Spatial inhomogeneity of the superconducting gap and order parameter in FeSe0.4Te0.6
similarity 0.89U. R. Singh et al.
Source status unknown — claims are unverified
Superconductivity close to magnetic instability in Fe(Se1−xTex)0.82
similarity 0.89M. H. Fang et al.
Source status unknown — claims are unverified
Superconductivity close to magnetic instability in Fe(Se1-xTex)0.82
similarity 0.89M. H. Fang et al. · 2008 · arXiv:0807.4775
Source status unknown — claims are unverified
Influence of substitutional disorder on the electrical transport and the superconducting properties of FeTeSeS
similarity 0.89M. G. Rodríguez et al. · 2015 · arXiv:1507.07853
Source status unknown — claims are unverified
Effect of substitution and heat treatment route on polycrystalline FeSe0.5Te0.5 Superconductors
similarity 0.88Hacisalihoglu, Muammer Yasin & Yanmaz, Ekrem · 2012 · arXiv:1206.0401
Source status unknown — claims are unverified
Short-range incommensurate magnetic order near the superconducting phase boundary in Fe(1+d)Te(1-x)Se(x)
similarity 0.88Jinsheng Wen et al. · 2009 · arXiv:0906.3774
Source status unknown — claims are unverified