Noise of a superconducting magnetic flux sensor based on a proximity Josephson junction

R. N. Jabdaraghi; D. S. Golubev; J. P. Pekola; J. T. Peltonen

doi:10.1038/s41598-017-08710-7

← Back to search

Noise of a superconducting magnetic flux sensor based on a proximity Josephson junction

R. N. Jabdaraghi, D. S. Golubev, J. P. Pekola, J. T. Peltonen

arXiv:1705.06448 · DOI 10.1038/s41598-017-08710-7 · 2017-05-18 · Scientific Reports

T3experimental13 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We demonstrate simultaneous measurements of DC transport properties and flux noise of a hybrid superconducting magnetometer based on the proximity effect (superconducting quantum interference proximity transistor, SQUIPT). The noise is probed by a cryogenic amplifier operating in the frequency range of a few MHz. In our non-optimized device, we achieve minimum flux noise $\sim 4\;μΦ_0/Hz^{1/2}$, set by the shot noise of the probe tunnel junction. The flux noise performance can be improved by further optimization of the SQUIPT parameters, primarily minimization of the proximity junction length and cross section. Furthermore, the experiment demonstrates that the setup can be used to investigate shot noise in other nonlinear devices with high impedance. This technique opens the opportunity to measure sensitive magnetometers including SQUIPT devices with very low dissipation.