← Back to search

Utilization of the Superconducting Transition for Characterizing Low-Quality-Factor Superconducting Resonators

Yu-Cheng Chang, Bayan Karimi, Jorden Senior, Alberto Ronzani, Joonas T. Peltonen, Hsi-Sheng Goan, Chii-Dong Chen, Jukka P. Pekola

arXiv:1904.01781 · DOI 10.1063/1.5098310 · 2019-04-03 · Applied Physics Letters

T1theoretical8 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

Characterizing superconducting microwave resonators with highly dissipative elements is a technical challenge, but a requirement for implementing and understanding the operation of hybrid quantum devices involving dissipative elements, e.g. for thermal engineering and detection. We present experiments on $λ/4$ superconducting niobium coplanar waveguide (CPW) resonators, terminating at the antinode by a dissipative copper microstrip via aluminum leads, such that the resonator response is difficult to measure in a typical microwave environment. By measuring the transmission both above and below the superconducting transition of aluminum, we are able to isolate the resonance. We then experimentally verify this method with copper microstrips of increasing thicknesses, from 50 nm to 150 nm, and measure quality factors in the range of $10\sim67$ in a consistent way.

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
Nb

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown
Al

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown

Similar papers