Anomalous Frequency Noise from the Megahertz Channelizing Resonators in Frequency-Division Multiplexed Transition Edge Sensor Readout
John Groh, Kam Arnold, Jessica Avva, Darcy Barron, Kevin T. Crowley, Matt Dobbs, Tijmen de Haan, William Holzapfel, Adrian Lee, Lindsay Ng Lowry, Joshua Montgomery, Maximiliano Silva-Feaver, Aritoki Suzuki, Nathan Whitehorn
arXiv:2012.07077 · DOI 10.1109/TASC.2021.3065283 · 2020-12-13 · IEEE Transactions on Applied Superconductivity
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Superconducting lithographed resonators have a broad range of current and potential applications in the multiplexed readout of cryogenic detectors. Here, we focus on LC bandpass filters with resonances in the 1-5 MHz range used in the transition edge sensor (TES) bolometer readout of the Simons Array cosmic microwave background (CMB) experiment. In this readout scheme, each detector signal amplitude-modulates a sinusoidal carrier tone at the resonance frequency of the detector's accompanying LC filter. Many modulated signals are transmitted over the same wire pair, and quadrature demodulation recovers the complex detector signal. We observe a noise in the resonant frequencies of the LC filters, which presents primarily as a current-dependent noise in the quadrature component after demodulation. This noise has a rich phenomenology, bearing many similarities to that of two-level system (TLS) noise observed in similar resonators in the GHz regime. These similarities suggest a common physical origin, thereby offering a new regime in which the underlying physics might be probed. We further describe an observed non-orthogonality between this noise and the detector responsivities, and present laboratory measurements that bound the resulting sensitivity penalty expected in the Simons Array. From these results, we do not anticipate this noise to appreciably affect the overall Simons Array sensitivity, nor do we expect it to limit future implementations.
Similar papers
Temperature Dependence of the Frequency and Noise of Superconducting Coplanar Waveguide Resonators
similarity 0.88Shwetank Kumar et al. · 2008 · arXiv:0802.4268
Source status unknown — claims are unverified
Single-sideband modulator for frequency domain multiplexing of superconducting qubit readout
similarity 0.87Benjamin J. Chapman et al. · 2017 · arXiv:1703.01693
Source status unknown — claims are unverified
Dynamical decoupling and noise spectroscopy with a superconducting flux qubit
similarity 0.87Jonas Bylander et al. · 2011 · arXiv:1101.4707
Source status unknown — claims are unverified
A Model for Excess Johnson Noise in Superconducting Transition-edge Sensors
similarity 0.87Abigail Wessels et al. · 2019 · arXiv:1907.11343
Source status unknown — claims are unverified
Multiplexed dispersive readout of superconducting phase qubits
similarity 0.86Yu Chen et al. · 2012 · arXiv:1209.1781
Source status unknown — claims are unverified
Analytical model of the readout power and SQUID hysteresis parameter dependence of the resonator characteristics of microwave SQUID multiplexers
similarity 0.86Mathias Wegner et al. · 2021 · arXiv:2112.08278
Source status unknown — claims are unverified