Post-fabrication frequency trimming of coplanar-waveguide resonators in circuit QED quantum processors

S. Vallés-Sanclemente; S. L. M. van der Meer; M. Finkel; N. Muthusubramanian; M. Beekman; H. Ali; J. F. Marques; C. Zachariadis; H. M. Veen; T. Stavenga; N. Haider; L. DiCarlo

doi:10.1063/5.0148222

Post-fabrication frequency trimming of coplanar-waveguide resonators in circuit QED quantum processors

S. Vallés-Sanclemente, S. L. M. van der Meer, M. Finkel, N. Muthusubramanian, M. Beekman, H. Ali, J. F. Marques, C. Zachariadis, H. M. Veen, T. Stavenga, N. Haider, L. DiCarlo

arXiv:2302.10705 · DOI 10.1063/5.0148222 · 2023-02-21 · Applied Physics Letters

T3experimental12 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We present the use of grounding airbridge arrays to trim the frequency of microwave coplanar-waveguide (CPW) resonators post fabrication. This method is compatible with the fabrication steps of conventional CPW airbridges and crossovers and increases device yield by allowing compensation of design and fabrication uncertainty with $100~\mathrm{MHz}$ range and $10~\mathrm{MHz}$ resolution. We showcase two applications in circuit QED. The first is elimination of frequency crowding between resonators intended to readout different transmons by frequency-division multiplexing. The second is frequency matching of readout and Purcell-filter resonator pairs. Combining this matching with transmon frequency trimming by laser annealing reliably achieves fast and high-fidelity readout across 17-transmon quantum processors.