Supercurrent Time Division Multiplexing with Solid-State Integrated Hybrid Superconducting Electronics

Alessandro Paghi; Laura Borgongino; Simone Tortorella; Giorgio De Simoni; Elia Strambini; Lucia Sorba; Francesco Giazotto

doi:10.1038/s41467-025-62931-3

Supercurrent Time Division Multiplexing with Solid-State Integrated Hybrid Superconducting Electronics

Alessandro Paghi, Laura Borgongino, Simone Tortorella, Giorgio De Simoni, Elia Strambini, Lucia Sorba, Francesco Giazotto

arXiv:2410.11721 · DOI 10.1038/s41467-025-62931-3 · 2024-10-15 · Nature Communications

T3experimental7 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

Time-division multiplexing of cryogenic signals is a promising approach to reduce space requirements, shorten cooldown times, and increase the number of quantum devices measured per cooldown. We demonstrate time-division multiplexing of non-dissipative supercurrents using voltage-controlled hybrid superconducting demultiplexers. These chips integrate superconducting Josephson Field Effect Transistors including Al superconducting electrodes, proximitized semiconducting InAs channels, and hafnium oxide gate insulators. Each transistor fully suppresses the switching current and increases the resistance 20 times under a gate voltage of -4.5 V. A demultiplexer with one input and eight outputs showed a non-dissipative input range of +-2 uA, operating up to 100 MHz in signal frequency and 100 kHz in switching frequency at 50 mK. It achieved near-zero insertion loss in the superconducting state and an ON/OFF ratio of 17.5 dB. By optimizing the signal layout, the operation was extended up to 4 GHz using a demultiplexer with two outputs.