A Non-planar ReBCO Test Coil with 3D-printed Aluminum Support Structure for the EPOS Stellarator

Paul Huslage; Tristan Schuler; Pedro F. Gil; Vitali Brack; Dylan Schmeling; Diego A. R. Orona; Elisabeth von Schoenberg; Timo Thun; Jason. Smoniewski; Eve V. Stenson

A Non-planar ReBCO Test Coil with 3D-printed Aluminum Support Structure for the EPOS Stellarator

Paul Huslage, Tristan Schuler, Pedro F. Gil, Vitali Brack, Dylan Schmeling, Diego A. R. Orona, Elisabeth von Schoenberg, Timo Thun, Jason. Smoniewski, Eve V. Stenson

arXiv:2505.08488 · 2025-05-13

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We report on the test of a small scale, non-planar coil using non-insulated ReBCO tape wound on a 3D-printed aluminum support structure. A 3D-scan of the winding frame which was printed out of AlSi10Mg using selective laser melting, showed peak manufacturing deviations of 0.3 mm. We tested the coil with 21 turns of 3 mm wide tape cooled both by liquid nitrogen and with a cryocooler. We achieved a central field strength of up to 21 mT which agrees with the prediction suggesting that we manufactured the coil without defects. The peak field was reached at a supply current of 120 A. The current leads showed a contact resistance of $\left(2.25\pm0.13\right)μΩ$. The discharge time $L/R$ was found to be 0.63 s in liquid nitrogen and 2.92 s when cooled by the cryocooler. From this we estimate a winding pack temperature of 41 K.