← Back to search

Inductive measurements of third-harmonic voltage and critical current density in bulk superconductors

Yasunori Mawatari, Hirofumi Yamasaki, Yoshihiko Nakagawa

arXiv:cond-mat/0307271 · DOI 10.1063/1.1625423 · 2003-07-11 · Applied Physics Letters

T1theoretical36 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We propose an inductive method to measure critical current density $J_c$ in bulk superconductors. In this method, an ac magnetic field is generated by a drive current $I_0$ flowing in a small coil mounted just above the flat surface of superconductors, and the third-harmonic voltage $V_3$ induced in the coil is detected. We present theoretical calculation based on the critical state model for the ac response of bulk superconductors, and we show that the third-harmonic voltage detected in the inductive measurements is expressed as $V_3= G_3ωI_0^2/J_c$, where $ω/2π$ is the frequency of the drive current, and $G_3$ is a factor determined by the configuration of the coil. We measured the $I_0$-$V_3$ curves of a melt-textured $\rm YBa_2Cu_3O_{7-δ}$ bulk sample, and evaluated the $J_c$ by using the theoretical results.

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
YBa2Cu3O7-δ

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown

Similar papers