← Back to search

Dynamic response of HTS composite tapes to pulsed currents

V. Meerovich, V. Sokolovsky, L. Prigozhin, D. Rozman

arXiv:cond-mat/0511365 · DOI 10.1088/0953-2048/19/4/004 · 2005-11-15 · Superconductor Science and Technology

T317 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

Dynamic voltage-current characteristics of an HTS Ag/BiSCCO composite tape are studied both experimentally and theoretically. The tape is subjected by pulsed currents with different shapes and magnitude and voltage traces are measured using the four-point method with different location of potential taps on the sample surface. Clockwise and anticlockwise hysteresis loops are obtained for the same sample depending on location of the potential taps. The dynamic characteristics deviate substantially from the DC characteristic, especially in the range of low voltages where a criterion for the critical current value is usually chosen (1-10 mkV/cm). The critical current determined from dynamic characteristics and its change with the pulse magnitude depend on location of the potential taps and on the curve branch chosen for the critical current determination (ascending or descending). The theoretical analysis is based on a model of the magnetic flux diffusion into a composite tape for a superconductor described by the flux creep characteristic. Numerical simulation based on this model gives the results in good agreement with the experimental ones and explains the observed peculiarities of the dynamic characteristics of HTS composite tapes. The difference between the magnetic diffusion into a tape and a slab is discussed.

Similar papers