Synthesis, characterization and low temperature studies of iron chalcogenide superconductors
J. Janaki, T. Geetha Kumary, Awadhesh Mani, S. Kalavathi, G V R Reddy, G. V. Narasimha Rao, A. Bharathi
arXiv:0904.3851 · DOI 10.1002/CHIN.201005004 · 2009-04-24 · arXiv: Superconductivity
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
We have synthesized tetragonal iron selenide and telluride superconductors through solid state reaction at 450deg.C and 550deg.C respectively. These synthesis temperatures have been established by optimization. Electrical resistivity and magnetic susceptibility measurements (4.2-300 K) confirm superconductivity with Tc of around 8.5 K in all selenide samples of nominal composition Fe1+deltaSe (delta=0.02-0.22). However, Scanning Electron Microscopy/ Energy Dispersive Spectroscopy studies clearly indicate that the actual stoichiometric ratio of Fe : Se for all the samples synthesized is around 1:1. Also all the samples exhibit identical phase transition temperatures from tetragonal to orthorhombic structure below ~ 100 K implying identical phase composition. The partial substitution of Se by Te leads to an enhancement of Tc to ~ 13 K. The non-superconducting telluride Fe1.09Te exhibits a metal-insulator phase transition at ~ 82 K. Substitution studies of this telluride system by S and Si have in addition been carried out to investigate if chemical pressure induces superconductivity.
Source-reported materials — not catalogue approval
| Formula | Reported Tc (K) | Pressure (GPa) | Type |
|---|---|---|---|
| FeSe Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 8.5 | Pressure not reported | unknown |
| FeSe Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 8.5 | Pressure not reported | unknown |
| FeSe1-xTex Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 13 | Pressure not reported | unknown |
| FeSe1-xTex Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 13 | Pressure not reported | unknown |
Similar papers
Effect of substitution and heat treatment route on polycrystalline FeSe0.5Te0.5 Superconductors
similarity 0.92Hacisalihoglu, Muammer Yasin & Yanmaz, Ekrem · 2012 · arXiv:1206.0401
Source status unknown — claims are unverified
Substitution Effects on FeSe Superconductor
similarity 0.89Y. Mizuguchi et al. · 2008 · arXiv:0811.1123
Source status unknown — claims are unverified
Effects of substituting Se with Te in the FeSe compound: structural, magnetization and Moessbauer studies
similarity 0.89R. W. Gómez et al. · 2009 · arXiv:0910.2504
Source status unknown — claims are unverified
Flux free growth of superconducting FeSe single crystals
similarity 0.89P. K. Maheshwari et al. · 2016 · arXiv:1606.08201
Source status unknown — claims are unverified
Superconducting Fe(1+delta)Se(1-x)Te(x) thin films: Growth, characterization and properties
similarity 0.88T. Geetha Kumary et al. · 2009 · arXiv:0904.1502
Source status unknown — claims are unverified
FeTeSe: a multiband superconductor in the clean and dirty limit
similarity 0.88C. C. Homes et al. · 2015 · arXiv:1502.07604
Source status unknown — claims are unverified