Two-level system noise reduction for Microwave Kinetic Inductance Detectors
Omid Noroozian, Jiansong Gao, Jonas Zmuidzinas, Henry G. LeDuc, Benjamin A. Mazin
arXiv:0909.2060 · DOI 10.1063/1.3292302 · 2009-09-10
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Noise performance is one of the most crucial aspects of any detector. Superconducting Microwave Kinetic Inductance Detectors (MKIDs) have an "excess" frequency noise that shows up as a small time dependent jitter of the resonance frequency characterized by the frequency noise power spectrum measured in units of Hz^2/Hz. Recent studies have shown that this noise almost certainly originates from a surface layer of two-level system (TLS) defects on the metallization or substrate. Fluctuation of these TLSs introduces noise in the resonator due to coupling of the TLS electric dipole moments to the resonator's electric field. Motivated by a semi-empirical quantitative theory of this noise mechanism, we have designed and tested new resonator geometries in which the high-field "capacitive" portion of the CPW resonator is replaced by an interdigitated capacitor (IDC) structure with 10 - 20 micron electrode spacing, as compared to the 2 micron spacing used for our more conventional CPW resonators. Measurements show that this new IDC design has dramatically lower TLS noise, currently by about a factor of ~29 in terms of the frequency noise power spectrum, corresponding to an improvement of about a factor of 29^(1/2) in NEP. These new devices are replacing the CPW resonators in our next design iteration in progress for MKIDCam. Opportunities and prospects for future reduction of the TLS noise will be discussed.
Similar papers
Crosstalk Reduction for Superconducting Microwave Resonator Arrays
similarity 0.89Omid Noroozian et al. · 2012 · arXiv:1206.5571
Source status unknown — claims are unverified
Geometry dependence of two-level-system noise and loss in a-SiC:H parallel-plate capacitors for superconducting microwave resonators
similarity 0.89K. Kouwenhoven et al.
Source status unknown — claims are unverified
Tunable responsivity and bandwidth in microwave kinetic inductance detectors via readout current nonlinearity
similarity 0.87Maclean Rouble et al. · 2026 · arXiv:2607.09178
Source status unknown — claims are unverified
Power Handling and Responsivity of Submicron Wide Superconducting Coplanar Waveguide Resonators
similarity 0.87R. M. J. Janssen et al. · 2012 · arXiv:1206.0579
Source status unknown — claims are unverified
Strategies for reducing frequency scatter in large arrays of superconducting resonators
similarity 0.86J. Li et al. · 2022 · arXiv:2203.17244
Source status unknown — claims are unverified
Noise Properties of Superconducting Coplanar Waveguide Microwave Resonators
similarity 0.86Jiansong Gao et al. · 2006 · arXiv:cond-mat/0609614
Source status unknown — claims are unverified