← Back to search

Anisotropic magnetism, superconductivity, and the phase diagram of Rb(1-x)Fe(2-y)Se2

V. Tsurkan, J. Deisenhofer, A. Günther, H. -A. Krug von Nidda, S. Widmann, A. Loidl

arXiv:1107.3932 · DOI 10.1103/PhysRevB.84.144520 · 2011-07-20 · Physical Review B

T1experimental45 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We report the crystal growth and structural, magnetic, conductivity, and specific heat investigations of Rb(1-x)Fe(2-y)Se2 single crystals with varying stoichiometry prepared by self-flux and Bridgman methods. The system exhibits a strongly anisotropic antiferromagnetic behavior below 400 K. For 1.53 <2-y< 1.6 superconductivity is found, whereas for Fe concentrations 2-y< 1.5 and 2-y> 1.6 insulating and semiconducting behavior is observed, respectively. The sharpest transition to the superconducting state and the highest transition temperature T_c of 32.4 K is found for compositions close to Rb2Fe4Se5. A critical current density j_c of 1.6*10^4 A/cm^2 (at 2 K) is obtained in the superconducting samples with the highest diamagnetic response. In these samples additional intense x-ray reflexes appear, which are incompatible with the tetragonal symmetry. Upper critical fields H_{c2} of ~250 kOe for the in-plane and 630 kOe for the inter-plane configurations are estimated from resistivity in magnetic fields parallel and perpendicular to the c-axis, respectively. In the non-superconducting samples with the Fe concentration below 1.45 both specific heat and susceptibility revealed an anomaly at 220 K which is not related to antiferromagnetic or structural transformations. Comparison with the magnetic behavior of non-superconducting samples provides evidence for the coexistence of superconductivity and static antiferromagnetic order.

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
Rb0.8Fe1.6Se2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

32.4Pressure not reportedonset
Rb0.8Fe1.6Se2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown
FeSe

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

8Pressure unresolvedunknown
FeSe

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

37Pressure not reportedunknown
Fe(Se,Te)

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

14Pressure not reportedunknown
KFeSe

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

30Pressure not reportedunknown
RbFeSe

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown
CsFeSe

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown

Similar papers