← Back to search

Specific Heat Discontinuity DeltaC vs Tc in Annealed Ba(Fe1-xCox)2As2

J. S. Kim, B. D. Faeth, G. R. Stewart

arXiv:1208.2492 · DOI 10.1103/PhysRevB.86.054509 · 2012-08-13 · Physical Review B

T1experimental6 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

The low temperature specific heat of annealed single crystal samples of Ba(Fe1-xCox)2As2 with compositions spanning the entire superconducting phase diagram was measured. Effort was made to discover the best annealing schedule to maximize Tc and minimize transition width in these samples. Values of deltaC/Tc normalized to 100% superconducting volume fractions varied proportionally to Tc^alpha. Within a rather narrow error bar of +-0.15, the exponent alpha was the same (approximately 2) over a range of compositions (0.055 < x < 0.15) around the optimal concentration, x=0.08, where Tc is the maximum in the phase diagram. Thus, whether the superconductivity was coexistent with magnetism (underdoped) or not (overdoped) did not affect the non-BCS variation (alpha nearly 2 instead of 0.8-0.9 for BCS superconductors) of deltaC/Tc with Tc. The annealed samples in the present work, with increased deltaC/Tc and Tc values compared to previous results for the Ba(Fe1-xCox)2As2 alloy system, suggest that the intrinsic value of the exponent alpha for the iron superconductors, when the samples are annealed, with fewer defects, may indeed be even further from the BCS value of 0.8-0.9 than previously thought.

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
Ba(Fe1-xCox)2As2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

—Pressure not reportedunknown

Similar papers