Comparison and Analysis of Twist Pitch Length Test Methods for ITER Nb3Sn and NbTi Strands

Fang Liu; Feng Long; Chao Chen; Bo Liu; Yu Wu; Huajun Liu

doi:10.1016/s1875-5372(16)30004-2

← Back to search

Comparison and Analysis of Twist Pitch Length Test Methods for ITER Nb3Sn and NbTi Strands

Fang Liu, Feng Long, Chao Chen, Bo Liu, Yu Wu, Huajun Liu

arXiv:1305.1688 · DOI 10.1016/s1875-5372(16)30004-2 · 2013-05-08 · arXiv: Accelerator Physics

T32 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

A twisted multifilamentary structure is needed for Nb3Sn and NbTi strands to be used in the International Thermonuclear Experimental Reactor (ITER) magnets. As important parameters for the superconducting strands design and production, the twist pitch length and direction of strands must meet the requirements according to ITER Procurement Arrangement (PA) and this must be verified. The technical requirements are 15mm+/-2mm for twist pitch length and right hand twist for direction. The strand twist pitch and the twist direction can be measured on straight sections of strand, which is recognized by the repetition of filament bundles or by the angle of the filaments. Several test methods and results are described and compared in this paper. The accuracy, uncertainty and feasibility of different methods are analyzed and recommended measurement methods are proposed for ITER strands verification.