Analysis of characteristics of Al MKID resonators
Takashi Noguchi, Agnes Dominjon, Yutaro Sekimoto
arXiv:1709.10421 · DOI 10.1109/TASC.2018.2809615 · 2017-09-29 · IEEE Transactions on Applied Superconductivity
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
We have prepared two kinds of Al resonators using thin films made by evaporation or sputtering and studied temperature behavior of their quality factors and resonance frequencies with the help of the extended Mattis-Bardeen (M-B) equations and its approximated analytical expressions. We have found that temperature behavior of both the internal quality factor and resonance frequency shift measured in evaporated Al thin-film resonators are well agreed with those calculated by the analytical expressions of the complex conductivity given by the M-B theory. In the Al thin film resonators made by sputtering, the internal quality factor and resonance frequency shift show a peak and a bump near 0.17 K in the respective temperature dependence. It is found that inverse of the internal quality factor is well approximated by a-b*log(T) below 0.15 K, where T is the temperature. This type of temperature dependence strongly indicates the existence of the magnetic impurity scattering of residual quasiparticles due to the Kondo effect. It is shown that temperature dependence of the internal quality factor and resonance frequency shift observed in the sputtered Al resonators can be well fitted by the theory taking the Kondo effect and kinetic inductance of the residual quasiparticles into account.
Similar papers
Contribution of residual quasiparticles to the characteristics of superconducting thin-film resonators
similarity 0.88T. Noguchi et al. · 2020 · arXiv:2012.04895
Source status unknown — claims are unverified
Measuring kinetic inductance and superfluid stiffness of two-dimensional superconductors using high-quality transmission-line resonators
similarity 0.87Mary Kreidel et al. · 2024 · arXiv:2407.09916
Source status unknown — claims are unverified
Planar Superconducting Resonators with Internal Quality Factors above One Million
similarity 0.87A. Megrant et al. · 2012 · arXiv:1201.3384
Source status unknown — claims are unverified
Equivalence of Optical and Electrical Noise Equivalent Power of Hybrid NbTiN-Al Microwave Kinetic Inductance Detectors
similarity 0.87R. M. J. Janssen et al. · 2014 · arXiv:1408.3272
Source status unknown — claims are unverified
Utilization of the Superconducting Transition for Characterizing Low-Quality-Factor Superconducting Resonators
similarity 0.86Yu-Cheng Chang et al. · 2019 · arXiv:1904.01781
Source status unknown — claims are unverified
Propagation velocity measurements of substrate phonon bursts using MKIDs for superconducting circuits
similarity 0.86Guy Moshel et al. · 2025 · arXiv:2501.03011
Source status unknown — claims are unverified