Current density distribution in resistive fault current limiters and its effect on device stability
Mohammad Farokhiyan, Mehdi Hosseini, Abdollah Kavousi-Fard
arXiv:2003.01399 · DOI 10.1016/j.physc.2020.1353786 · 2020-03-03 · arXiv: Applied Physics
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
The increase of current uniformity along of a resistive type superconductor fault current limiter (R-SFCL) in the design of this type of limiters is well perceived as an important issue. The non-uniform distribution of current in R-SFCL only increases the current in some superconducting regions, as a result, in the fault conditions, only certain parts of the superconductor undergo a phase change that increases the heat pressure in those areas and causes the breakdown and destruction of the device. In this paper, the current density distributions in common patterns used in R-SFCs constructions have been simulated and investigated. To this end, an effective model is proposed for R-SFCL to achieve the highest uniformity of current and harmonic phase change over superconductors compared to other patterns. The simulation results in the Ansys Maxwell Software advocate the appropriate and satisfying performance of the proposed model.
Similar papers
Transient stability of a power system with superconducting fault current limiters
similarity 0.89V. Sokolovsky et al. · 2007 · arXiv:cond-mat/0701308
Source status unknown — claims are unverified
Thermal Instability and Current-Voltage Scaling in Superconducting Fault Current Limiters
similarity 0.89Bernhard Zeimetz et al. · 2003 · arXiv:cond-mat/0312190
Source status unknown — claims are unverified
Implementation of Resistive Type Superconducting Fault Current Limiters in Electrical Grids: Performance Analysis and Measuring of Optimal Locations
similarity 0.87Xiuchang Zhang et al. · 2016 · arXiv:1508.01162
Source status unknown — claims are unverified
Demonstration of a three-dimensional current mapping technique around a superconductor in a prototype of a conventional superconducting fault current limiter
similarity 0.86Md. Arif Ali & S. S. Banerjee · 2021 · arXiv:2112.00433
Source status unknown — claims are unverified
An improved design of an inductive fault current limiter based on a superconducting cylinder
similarity 0.86Vladimir Sokolovsky et al. · 2010 · arXiv:1003.3993
Source status unknown — claims are unverified