50 Ohm Transmission Lines with Extreme Wavelength Compression Based on Superconducting Nanowires on High-Permittivity Substrates
Daniel F. Santavicca, Marco Colangelo, Carleigh R. Eagle, Maitri P. Warusawithana, Karl K. Berggren
arXiv:2111.01006 · DOI 10.1063/5.0077008 · 2021-11-01 · Applied Physics Letters
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
We demonstrate impedance-matched low-loss transmission lines with a signal wavelength more than 150 times smaller than the free space wavelength using superconducting nanowires on high permittivity substrates. A niobium nitride thin film is patterned in a coplanar waveguide (CPW) transmission line geometry on a bilayer substrate consisting of 100 nm of epitaxial strontium titanate on high-resitivity silicon. The use of strontium titanate on silicon enables wafer-scale fabrication and maximizes process compatibility. It also makes it possible to realize a $50$ $Ω$ characteristic impedance across a wide range of CPW widths, from the nanoscale to the macroscale. We fabricated and characterized an approximately $50$ $Ω$ CPW device with two half-wave stub resonators. Comparing the measured transmission coefficient to numerical simulations, we determine that the strontium titanate film has a dielectric constant of $1.1 \times 10^3$ and a loss tangent of not more than 0.009. To facilitate the design of distributed microwave devices based on this type of material system, we describe an analytical model of the CPW properties that gives good agreement with both measurements and simulations.
Source-reported materials — not catalogue approval
| Formula | Reported Tc (K) | Pressure (GPa) | Type |
|---|---|---|---|
| NbN Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 12 | Pressure not reported | unknown |
Similar papers
Fabrication and surface treatment of electron-beam evaporated niobium for low-loss coplanar waveguide resonators
similarity 0.88D. Kowsari et al. · 2021 · arXiv:2108.05354
Source status unknown — claims are unverified
Power Handling and Responsivity of Submicron Wide Superconducting Coplanar Waveguide Resonators
similarity 0.87R. M. J. Janssen et al. · 2012 · arXiv:1206.0579
Source status unknown — claims are unverified
Towards highly efficient broadband superconducting quantum memory
similarity 0.87A. R. Matanin et al. · 2022 · arXiv:2207.14092
Source status unknown — claims are unverified
Fast tuning of superconducting microwave cavities
similarity 0.87M. Sandberg et al. · 2008 · arXiv:0811.4449
Source status unknown — claims are unverified
Single Superconducting Split-Ring Resonator Electrodynamics
similarity 0.86Ricci, Michael C. & Anlage, Steven M. · 2006 · arXiv:cond-mat/0512515
Source status unknown — claims are unverified
Epitaxial growth and transport properties of Nb-doped SrTiO thin films
similarity 0.86K. S. Takahashi et al. · 2005 · arXiv:cond-mat/0508073
Source status unknown — claims are unverified