Detector Array Readout with Traveling Wave Amplifiers
A. Giachero, C. Barone, M. Borghesi, G. Carapella, A. P. Caricato, I. Carusotto, W. Chang, A. Cian, D. Di Gioacchino, E. Enrico, P. Falferi, L. Fasolo, M. Faverzani, E. Ferri, G. Filatrella, C. Gatti, D. Giubertoni, A. Greco, C. Kutlu, A. Leo, C. Ligi, G. Maccarrone, B. Margesin, G. Maruccio, A. Matlashov, C. Mauro, R. Mezzena, A. G. Monteduro, A. Nucciotti, L. Oberto, S. Pagano, V. Pierro, L. Piersanti, M. Rajteri, S. Rizzato, Y. K. Semertzidis, S. Uchaikin, A. Vinante
arXiv:2111.01512 · DOI 10.1007/s10909-022-02809-6 · 2021-11-02 · Journal of Low Temperature Physics
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Noise at the quantum limit over a large bandwidth is a fundamental requirement for future applications operating at millikelvin temperatures, such as the neutrino mass measurement, the next-generation x-ray observatory, the CMB measurement, the dark matter and axion detection, and the rapid high-fidelity readout of superconducting qubits. The read out sensitivity of arrays of microcalorimeter detectors, resonant axion-detectors, and qubits, is currently limited by the noise temperature and bandwidth of the cryogenic amplifiers. The DARTWARS (Detector Array Readout with Traveling Wave AmplifieRS) project has the goal of developing high-performing innovative traveling wave parametric amplifiers (TWPAs) with a high gain, a high saturation power, and a quantum-limited or nearly quantum-limited noise. The practical development follows two different promising approaches, one based on the Josephson junctions and the other one based on the kinetic inductance of a high-resistivity superconductor. In this contribution we present the aims of the project, the adopted design solutions and preliminary results from simulations and measurements.
Source-reported materials — not catalogue approval
| Formula | Reported Tc (K) | Pressure (GPa) | Type |
|---|---|---|---|
| NbTiN Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 15 | Pressure not reported | unknown |
| Nb0.66Ti0.34 Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | 14.08 | Pressure not reported | unknown |
Similar papers
Simulating the behaviour of travelling wave superconducting parametric amplifiers using a commercial circuit simulator
similarity 0.91T. Sweetnam et al. · 2022 · arXiv:2203.09660
Source status unknown — claims are unverified
Flux-driven Josephson traveling-wave parametric amplifier
similarity 0.90A. B. Zorin · 2018 · arXiv:1804.09109
Source status unknown — claims are unverified
Josephson traveling-wave parametric amplifier with three-wave mixing
similarity 0.89A. B. Zorin · 2016 · arXiv:1602.02650
Source status unknown — claims are unverified
Josephson Traveling-Wave Parametric Amplifier with Inverse Kerr Phase Matching
similarity 0.88M. T. Bell · 2025 · arXiv:2507.17039
Source status unknown — claims are unverified
Simulation and Analysis of Superconducting Traveling-Wave Parametric Amplifiers
similarity 0.88Saptarshi Chaudhuri et al. · 2014 · arXiv:1412.2372
Source status unknown — claims are unverified
Characterization of NbTiN films with thicknesses below 20 nm for low power kinetic inductance amplifiers
similarity 0.87A. Giachero et al. · 2024 · arXiv:2402.11720
Source status unknown — claims are unverified