← Back to search

Millimetre Wave Kinetic Inductance Parametric Amplification using Ridge Gap Waveguide

Danielius Banys, Mark Anthony McCulloch, Thomas Sweetnam, Valerio Gilles, Lucio Piccirillo

arXiv:2111.06416 · DOI 10.1007/s10909-022-02859-w · 2021-11-11 · Journal of Low Temperature Physics

T1theoretical1 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We present the design and simulation methodology of a superconducting ridge-gap waveguide (RGWG) as a potential basis for mm-wave kinetic inductance travelling wave parametric amplifiers (KI-TWPAs). A superconducting RGWG was designed using Ansys HFSS to support a quasi-TEM mode of transmission over a bandwidth of 20 to 120 GHz with its internal dimensions optimised for integration with W-band rectangular waveguide. A design of an impedance loaded travelling wave structure incorporating periodic perturbations of the ridge was described. A method to simulate the nonlinear kinetic inductance via user-defined components in Keysight's ADS was outlined, which yielded the power dependent S-parameters and parametric signal gain. A RGWG with a 30 nm NbTiN coating and 5 um conductor spacing, corresponding to a kinetic inductance fraction $α\sim 60\%$ was used for the description of a KI-TWPA with 900 perturbations equivalent to a physical length 25 cm that achieved more than 10 dB of signal gain over a 75--110 GHz bandwidth via 4-wave mixing (4WM).

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
NbTiN

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

12.5Pressure not reportedunknown

Similar papers