Dual-Resonator Kinetic-Inductance Detector for Distinction between Signal and 1/f Frequency Noise
N. Foroozani, B. Sarabi, S. H. Moseley, T. Stevenson, E. J. Wollack, O. Noroozian, K. D. Osborn
arXiv:2202.11310 · 2022-02-23
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Astronomical Kinetic Inductance Detectors (KIDs), similar to quantum information devices, experience performance limiting noise from materials. In particular, 1/f (frequency) noise can be a dominant noise mechanism, which arises from Two-Level System defects (TLSs) in the circuit dielectrics and material interfaces. Here we present a Dual-Resonator KID (DuRKID), which is designed for improved signal to noise (or noise equivalent power) relative to 1/f-noise limited KIDs. We first show the DuRKID schematic, fabricated circuit, and we follow with a description of the intended operation, first measurements, theory, and discussion. The circuit consists of two superconducting resonators sharing an electrical capacitance bridge of 4 capacitors, each of which hosts TLSs. The device is intended to operate using hybridization of the modes, which causes TLSs to either couple to one mode or the other, depending upon which capacitor they reside in. In contrast, the intended KID signal is directed to an inductor, and due to hybridization this causes correlated frequency changes in both (hybridized) modes. Therefore, one can distinguish photon signal from TLS frequency noise. To achieve hybridization, a TiN inductor is current biased to allow tuning of one bare resonator mode into degeneracy with the other and measurements show that the intended resonator modes frequency tune and hybridize as expected. The interresonator coupling and unintentional coupling of the 2 resonators to transmission lines are also characterized in measurements. In the theory, based on a quantum-information-science modes, we calculate the 4-port S parameters and simulate the 1/f frequency noise of the device. The study reveals that the DuRKID can exhibit a large and fundamental performance advantage over 1/f-noise-limited KID detectors.
Similar papers
The thermally-coupled imager: A scalable readout architecture for superconducting nanowire single photon detectors
similarity 0.92Adam N. McCaughan et al. · 2021 · arXiv:2112.04705
Source status unknown — claims are unverified
Excess noise in the anomalous metallic phase in amorphous indium oxide
similarity 0.91André Haug & Dan Shahar · 2023 · arXiv:2305.15931
Source status unknown — claims are unverified
Collective modes in terahertz field response of superconductors with paramagnetic impurities
similarity 0.91Yantao Li & Maxim Dzero · 2024 · arXiv:2403.03980
Source status unknown — claims are unverified
Dissipation Induced Flat Bands
similarity 0.90Spenser Talkington & Martin Claassen · 2022 · arXiv:2203.07453
Source status unknown — claims are unverified
Vector graphics extraction and analysis of electrical resistance data in Nature volume 586, pages 373-377 (2020)
similarity 0.90James J. Hamlin · 2022 · arXiv:2210.10766
Source status unknown — claims are unverified
Enhancement of Superconductivity in a Dirty Marginal Fermi Liquid
similarity 0.90Tsz Chun Wu et al. · 2023 · arXiv:2305.13357
Source status unknown — claims are unverified