Critical current densities and microstructures in Rod-in-Tube and Tube Type Nb3Sn strands - Present status and prospects for improvement
X Xu, M D Sumption, S Bhartiya, X Peng, E W Collings
arXiv:1304.6025 · DOI 10.1088/0953-2048/26/7/075015 · 2013-04-22 · Superconductor Science and Technology
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
In this work, the transport and magnetization properties of distributed-barrier Rod-in-Tube (RIT) strands and Tube Type strands are studied. While Tube Type strands had smaller magnetizations and thus better stabilities in the low field region, their 12 T non-Cu Jcs were somewhat smaller than those of the RIT strands. Microstructures were investigated in order to find out the reasons for the difference in non-Cu Jc values. Their grain size and stoichiometry were found to be comparable, leading to similar layer Jcs. Accordingly it was determined that the lower A15 area fraction rather than the quality of A15 layer was the cause of the discrepancy in non-Cu Jc. Subsequently, the area utilizations of subelements were investigated. While for a RIT strand the fine grain (FG) A15 area occupies ~60% of a subelement, for a Tube Type strand it is no more than 40%. Further analysis indicates that the low FG area fraction in a Tube Type strand is attributed to its much larger unreacted Nb area fraction. Finally, a simple change in strand architecture is proposed to reduce the unreacted Nb area fraction.
Similar papers
Examination of the tradeoff between intrinsic and extrinsic properties in the optimization of a modern internal tin Nb3Sn conductor
similarity 0.88C. Tarantini et al. · 2013 · arXiv:1310.6729
Source status unknown — claims are unverified
Simulations of the effects of tin composition gradients on the superconducting properties of Nb3Sn conductors
similarity 0.85L. D. Cooley et al. · 2004 · arXiv:cond-mat/0402206
Source status unknown — claims are unverified
A review and prospects for Nb3Sn superconductor development
similarity 0.84Xingchen Xu · 2017 · arXiv:1706.10253
Source status unknown — claims are unverified
Evidence from EXAFS for Different Ta/Ti Site Occupancy in High Critical Current Density NbSn Superconductor Wires
similarity 0.83Steve M. Heald et al. · 2018 · arXiv:1803.07025
Source status unknown — claims are unverified
High transport critical current density obtained for Powder-In-Tube-processed MgB2 tapes and wires using stainless steel and Cu-Ni tubes
similarity 0.83H. Kumakura et al. · 2001 · arXiv:cond-mat/0106002
Source status unknown — claims are unverified
Performance Boost in Industrial Multifilamentary Nb3Sn Wires due to Radiation Induced Pinning Centers
similarity 0.83T. Baumgartner et al. · 2015 · arXiv:1504.05366
Source status unknown — claims are unverified