Observation of REBCO delamination in the resistive insulation nested coils

Jun Lu; Iain Dixon; Kwangmin Kim; Yan Xin; Hongyu Bai

← Back to search

Observation of REBCO delamination in the resistive insulation nested coils

Jun Lu, Iain Dixon, Kwangmin Kim, Yan Xin, Hongyu Bai

arXiv:2512.16647 · 2025-12-18

T3

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

The REBCO coated conductor has the potential to be widely used in ultrahigh field magnets. It is well known, however, that it is not mechanically strong against delamination in the direction normal to its surface due to its intrinsic layered structure. Therefore, conductor delamination is one of the major design challenges for REBCO magnet coils. As a part of the development of the 40 T all-superconducting magnet at the National High Magnetic Field Laboratory, USA (NHMFL), a dry-wound resistive-insulation-nested-coils (RINC) was designed to reach 25.8 T. It used surface-treated stainless-steel tape as a co-wind to control the turn-to-turn contact resistance, and was fabricated and tested in a liquid helium bath. During the test, two of the double pancake modules exhibited resistive transitions at a current significantly lower than the designed value. The postmortem inspection of the REBCO conductor of these modules by reel-to-reel magnetization at 77 K found sections of very low critical current. Further investigations of one section by chemical etching, visual inspection, and electron microscopy revealed that conductor of this section was delaminated. We present the detailed findings of these postmortem characterizations. The implication of this type of delamination for future magnet designs will be discussed.