Studies of YBCO Strip Lines under Voltage Pulses: Optimisation of the Design of Fault Current Limiters
M. Decroux, L. Antognazza, S. Reymond, W. Paul, M. Chen, O. Fischer
arXiv:cond-mat/0301382 · DOI 10.1109/TASC.2003.812959 · 2003-01-21 · IEEE Transactions on Applied Superconductivity
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
We present experimental results on the behaviour of a superconducting YBCO/Au meander of length L submitted to short circuit tests with constant voltage pulses. The meander, at the beginning of the short-circuit, is divided in two regions; one, with a length L1 proportional to the applied voltage, which first switches into a highly dissipative state (HDS) while the rest remains superconducting. Then the rest of the meander will progressively switch into the normal state due to the propagation of this HDS (few m/s) from both ends. The part L1 has to initially support a power density proportional to r.Jp^2 (r is the resistivity of the bilayer and Jp the peak current density). To avoid local excessive dissipation of power and over heating on one part of the wafer in the initial period, we have developed a novel design in order to distribute the dissipating section of the meander into many separated small dissipative zones. Furthermore the apparent propagation velocity of these dissipative zones is increased by the number of propagation fronts. We will show results obtained on 3kW (300V, 10A) FCL on a 2" wafer which confirm the benefits of this new design.
Source-reported materials — not catalogue approval
| Formula | Reported Tc (K) | Pressure (GPa) | Type |
|---|---|---|---|
| YBa2Cu3O7 Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | — | Pressure not reported | unknown |
Similar papers
Stability and normal zone propagation speed in YBCO coated conductors with increased interfacial resistance
similarity 0.84George A. Levin et al. · 2008 · arXiv:0808.3409
Source status unknown — claims are unverified
Current density distribution in resistive fault current limiters and its effect on device stability
similarity 0.84Mohammad Farokhiyan et al. · 2020 · arXiv:2003.01399
Source status unknown — claims are unverified
Nucleation of Stable Superconductivity in YBCO-Films
similarity 0.84J. Koetzler · 1999 · arXiv:cond-mat/9904279
Source status unknown — claims are unverified
High-temperature superconducting fault current microlimiters
similarity 0.83J. A. Lorenzo Fernandez et al. · 2009 · arXiv:0901.2299
Source status unknown — claims are unverified
Superconducting wires under simultaneous oscillating sources: involved magnetic response, dissipation of energy and low pass filtering
similarity 0.83H. S. Ruiz et al. · 2011 · arXiv:1108.0659
Source status unknown — claims are unverified
Patterning of ultrathin YBCO nanowires using a new focused-ion-beam process
similarity 0.83Curtz, Noé et al. · 2010 · arXiv:1002.0808
Source status unknown — claims are unverified