Aging of the HF−H2SO4 electrolyte used for the electropolishing of niobium superconducting radio frequency cavities: Origins and cure
F. Eozénou, S. Berry, C. Antoine, Y. Gasser, J.-P. Charrier, B. Malki
DOI 10.1103/PhysRevSTAB.13.083501 · Physical Review Special Topics - Accelerators and Beams
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Electropolishing (EP) in the HF−H2SO4 electrolyte is the most desirable surface treatment for niobium superconducting radio frequency cavities yet demonstrated, in terms of performance and surface finish. However, the efficiency of the electrolyte declines quickly with time (decrease in removal rate, deterioration of the niobium surface, increased sulfur generation). Previous studies at CEA Saclay have highlighted the impact of the water content in EP mixtures rather than the content of dissolved niobium. Knowledge of the electrochemical system was improved thanks to studies using a rotating disk electrode (RDE). Measurements with a RDE give precious information concerning mass transport of the different ionic groups present in the solution. The performed measurements prove that EP is controlled by the diffusion of fluorine ions and the value of the related diffusion coefficient DF− was estimated for different mixtures. Electrochemical impedance spectroscopy (EIS) measurements were also performed with different EP mixtures. Both volt ampere metric and EIS measurements prove the central role of fluorine during EP and show that EP mechanisms evolve with the aging of the bath. Another major problem related to electrolytes is the formation of impurities such as sulfur. We have proved that working at a reduced voltage of 5 V does not alter cavity performance and makes it possible to reduce the undesirable particulate contamination in electrolytes and to increase their lifetime.
Similar papers
Development of vertical electropolishing process applied on 1300 and 704 MHz superconducting niobium resonators
similarity 0.88F. Eozénou et al.
Source status unknown — claims are unverified
Vertical electropolishing for 1.3 GHz single- and nine-cell superconducting niobium cavities: A parametric optimization and rf performance
similarity 0.84Vijay Chouhan et al.
Source status unknown — claims are unverified
Electropolishing-Induced Topographic Defects in Niobium: Insights and Implications for Superconducting Radio Frequency Applications
similarity 0.84Oleksandr Hryhorenko et al. · 2025 · arXiv:2509.25423
Source status unknown — claims are unverified
Superconductivity Above H_{c2} as a Probe for Niobium RF-Cavity Surfaces
similarity 0.84Sara Casalbuoni et al. · 2003 · arXiv:cond-mat/0310565
Source status unknown — claims are unverified
Plasma treatment of bulk niobium surface for superconducting rf cavities: Optimization of the experimental conditions on flat samples
similarity 0.84M. Rašković et al.
Source status unknown — claims are unverified
Topographic evolution of heat-treated Nb upon electropolishing for superconducting rf applications
similarity 0.83Eric M. Lechner et al.
Source status unknown — claims are unverified