← Back to search

Low Temperature Fabrication of MgB2

N. Rogado, M. A. Hayward, K. A. Regan, Yayu Wang, N. P. Ong, John M. Rowell, R. J. Cava

arXiv:cond-mat/0107534 · DOI 10.1063/1.1420771 · 2001-07-25 · Journal of Applied Physics

T1theoretical38 citations

Active bibliographic source — not scientific approval

Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.

Abstract

We report the fabrication of MgB2 with bulk superconducting properties by conventional solid state methods at temperatures as low as 550 C. Mg deficiencies of the type Mg1-xB2 were tested. Tc was found to decrease by about 1K at large x, though the amount of non-stoichiometry, if any, is likely to be very small. For specific processing conditions, indications of the 25-30 K transition often seen in thin films were seen in the bulk materials. The lower temperature transition may be associated with the grain boundaries. These results indicate that it should be possible to fabricate MgB2 with bulk properties in in-situ thin films at temperatures of 600 C or less.

Source-reported materials — not catalogue approval

FormulaReported Tc (K)Pressure (GPa)Type
MgB2

Archive — visibility unverified

Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula.

27.5Pressure not reportedunknown

Similar papers