Mechanically reinforced MgB2 wires and tapes with high transport currents
R. Nast, S. I. Schlachter, S. Zimmer, H. Reiner, W. Goldacker
arXiv:cond-mat/0108458 · DOI 10.1016/S0921-4534(02)00982-6 · 2001-08-28 · Physica C-superconductivity and Its Applications
Active bibliographic source — not scientific approval
Bibliographic access preserves source history; it does not approve extracted materials or validate reported claims. Review warnings on each occurrence separately.
Abstract
Monofilamentary MgB2-wires with a 2- or 3-component sheath containing mechanical reinforcing stainless steel (SS) were prepared and characterized. In direct contact to the superconductor Nb, Ta or Fe was used. For a selection of samples with a Fe and Fe/SS sheath, we investigated the transport critical current behaviour in magnetic fields changing systematically the geometrical shape from a round wire to a flat tape. A strong increase of the current densities in flat tapes was observed and possible reasons for this are discussed. Reinforcing the sheath in the outer layer with different amounts of stainless steel leads to a systematic field dependent decrease of the transport critical current density with increasing steel amount. This is an indication for a pre-stress induced degradation of the critical currents in MgB2 wires and first Ic-stress-strain experiments seem to confirm this observation and interpretation.
Source-reported materials — not catalogue approval
| Formula | Reported Tc (K) | Pressure (GPa) | Type |
|---|---|---|---|
| MgB2 Archive — visibility unverified Source-occurrence policy only; no material identity or catalogue acceptance is inferred from the formula. | — | Pressure not reported | unknown |
Similar papers
High transport currents in mechanically reinforced MgB2 wires
similarity 0.93W. Goldacker et al. · 2001 · arXiv:cond-mat/0106226
Source status unknown — claims are unverified
Strain Effect in MgB2/Stainless Steel Superconducting Tape
similarity 0.91H. Kitaguchi et al. · 2001 · arXiv:cond-mat/0106388
Source status unknown — claims are unverified
Influence of the Preparation Process on Microstructure, Critical Current Density and Tc of MgB2 Powder-In-Tube Wires
similarity 0.91S. I. Schlachter et al. · 2002 · arXiv:cond-mat/0210591
Source status unknown — claims are unverified
Large transport critical currents in unsintered MgB2 superconducting tapes
similarity 0.90G. Grasso et al. · 2001 · arXiv:cond-mat/0103563
Source status unknown — claims are unverified
Fabrication and transport critical currents of multifilamentary MgB2/Fe wires and tapes
similarity 0.90H. L. Suo et al. · 2002 · arXiv:cond-mat/0203114
Source status unknown — claims are unverified
High transport critical current density obtained for Powder-In-Tube-processed MgB2 tapes and wires using stainless steel and Cu-Ni tubes
similarity 0.89H. Kumakura et al. · 2001 · arXiv:cond-mat/0106002
Source status unknown — claims are unverified